This week’s conundrum was a partially completed self-assembly canvas, originally supplied by post to our customer as a roll of canvas, four pre-cut lengths of wood for the frame, some double-sided tape and fixings. The recipient had followed the instructions but there was no way the frame would go together as the fixing screws wouldn’t go into the holes. Could we help?

Canvas kit
Canvas kit

A first attempt at putting it together resulted in similar failure. More thought required! The supplied instructions were brief, upbeat and not much help in solving the problem. However, there was a link to an on-line assembly video. In it, a young lady laid out all the pieces on a table and effortlessly put it all together in less than two minutes and with no adjustment or effort involved. Hmmm.

Back to the canvas.

Inspection of the brackets showed that they were not symmetrical and not all the parts lined up as they should. Also, one of the fixings was missing. A period of adjustment followed, resulting in a frame that looked like it had the potential to go together. Indeed it did, but only after application of a lot of pressure and with the benefit of a very strong grip to make the fixing screws tighten fully. The resulting canvas was nicely taut and will look lovely hanging on the owner’s wall in due course.

Finished, at last!

Reflecting on the job it seemed clear that the easy assembly shown in the instruction video did not reflect the reality. That young lady in the video must have been remarkably strong, or else was assembling one “they prepared earlier”! Our workshop has the benefit of an adequately large flat working surface, accessible from all sides, and a reasonable level of strength was required to finish the job. I doubt it could have been done in the confines of a living room or working on a carpeted floor.

Sometimes buying things sight-unseen is not ideal. Much better to see what you are getting “in the flesh” if at all possible. Shop local?

Mark