When hefting an unusually vast piece of glass across the workshop to slot it into the cutter the biggest difficulty is keeping it stable.
The uninitiated (which would be most of us) don’t usually cart around huge panes of breakable sharp stuff, so are not normally aware of the danger of it flexing and shattering. Do trust me on this – it isn’t fun when it happens.
I was asked to frame two very large posters for a friend recently. He specialises in sports massages for pain relief, and his enormous posters depict the trigger points for massage to relieve assorted bodily ills. I have to admit that doing his framing was a huge pain (and yes, I could have worked in ‘pane’ somewhere in there, but decided it would be way too cheesy, so I didn’t). I did, however, acquire some bodily ills of my own just lifting the things…

One of the large posters once safely in a frame…
It isn’t just the flexing that is a problem. The larger a piece of glass, the more variation there is to its particular fault lines. In other words, if you are making a long cut on a big piece, there is far more chance of the cut line you want going rogue somewhere along the demarcation, purely because of the distances involved. Sure, a small piece of glass can misbehave too, but it isn’t such a problem (or so expensive) to recut it.
The first of these two posters (over a metre wide and 700mm tall) nearly had me in tears. The first piece of glass broke unevenly, leaving a bulge at one end. Not usually a problem – one places the glass on a stable, flat surface, gently tap the problem area and very, very gently ‘bite’ off the offending protrusion with wide-headed glass pliers. It didn’t work – a gleeful little crack started to zip across the wrong side of the surface…
Sighing, I hauled out another mega pane to cut. This one decided to cut beautifully until I swiped to the bottom ten inches, then another crack opened up on the wrong side of the cut (it usually IS the wrong side of the cut).

Remnants of broken glass…
Third time lucky? No such luck. Same thing happened again, in the same place, so I was getting more than aeriated about even trying a fourth. However, you don’t give up when you have pictures to finish, so I gritted my teeth and got on with it. This time the Framing Fates decided to be kind, and the cut unzipped beautifully along its allocated line.
Because big pictures in slender frames need a bit of extra support, I used triple fixings on both to hold the whole together as securely as possible, and double-strength cord, to ‘belt and brace’ the whole.
Wouldn’t you know? The second (identically monster-sized) poster went together like a dream. That’s framing for you…
